Edmonton T-shirts

got the logos printed. here are the directions for doing your shirts or whatever you want to put your logo on.

What you need:
Works best on 100% preshrunk cotons, polyester blends or 100% Polyester Garments (white or light colours only: unlaundered or uncontaminated)

Using a Hand Iron:
Preheat iron on highest cotton setting. DO NOT USE STEAM
Preheat the garment to remove moisture from fabric.
Position transfer as desired, image side DOWN, onto garment
Press iron firmly over the transfer in a circular motions for 15-20 seconds in each position
Heat the entire surface of the transfer

Removal of Backing Paper
For a satin finish, remove the backing paper immediately after ironing while transfer is
still HOT.
For a glossy finish, wait untill the transferhas cooled completely and then remove the
backing paper.

Washing Instructions:
Transfers have a stiff feel to them when new. This feel will become softer as you wash the garment. Turn garment inside out. Machine wash cold or warm water. Use colour safe detergent, no bleach or softener. Remove immediately from washer. Colours may bleed if garment is left wet too long. If bleeding occurs. rewash immediately. Tumble dry low or air dry, Remove garment from dryer immediately. Do not iron directly on transfer. cover with silicone slip sheet or baking parchment and allow to cool before removing.

 

right so.................I will get someone who knows what they're doing to do mine. Check