Voice Editing w/ GoldWave

Discussion in 'FanForce Conventions' started by PwrOfTheForce, Jul 17, 2006.

Thread Status:
Not open for further replies.
  1. PwrOfTheForce Jedi Youngling

    Member Since:
    Jul 11, 2004
    Hi!
    Guys, I'm just wonderin' an' all, I'm trying to create a jango/boba fett-like voice using goldwave.:D I use my own voice, (but this is optional) and the best I've gotten was a terminator robotic voice with a low voice at start, and a higher volume and pitch around the end.[face_worried] Here's what I did:

    bandpass=
    1400 (first box)
    1600 (2nd box)

    1400 (1st box under bandpass)
    8000 (2nd box under bandpass)

    ºBandpass (check if needed)
    ºDynamic (also check if needed)

    Volume: 10 (or 10 ticks higher than 0.00)
    Speed 9 if needed, but more 10.


    Any help here would be hot.:(

    -Pwr

    What he said
  2. LukeSkiewalker Jedi Master

    Member Since:
    Apr 4, 2003
    star 4
    Depending on whether you are trying to make F/X box or you are wanting to do some sort of editing in a fan Film or something, You might try these Forums:

    [link=http://boards.theforce.net/costuming_and_props/b10019/p1]Costuming and Props[/link]
    [link=http://boards.theforce.net/fan_films/b10015/p1]Fan Films[/link]
    [link=http://boards.theforce.net/fan_audio/b10565/p1]Fan Audio[/link]

    I don't think you are going to get much help in the conventions forum ;)
Thread Status:
Not open for further replies.