Voice Editing w/ GoldWave

Hi!
Guys, I'm just wonderin' an' all, I'm trying to create a jango/boba fett-like voice using goldwave. I use my own voice, (but this is optional) and the best I've gotten was a terminator robotic voice with a low voice at start, and a higher volume and pitch around the end. Here's what I did:

bandpass=
1400 (first box)
1600 (2nd box)

1400 (1st box under bandpass)
8000 (2nd box under bandpass)

ºBandpass (check if needed)
ºDynamic (also check if needed)

Volume: 10 (or 10 ticks higher than 0.00)
Speed 9 if needed, but more 10.

Any help here would be hot.

-Pwr

What he said

 

Depending on whether you are trying to make F/X box or you are wanting to do some sort of editing in a fan Film or something, You might try these Forums:

Costuming and Props
Fan Films
Fan Audio

I don't think you are going to get much help in the conventions forum